In particular, we demonstrated live our new development for tests according to LV148 – E05, superimposed voltages 30kHz—200kHz, whereby we interpret this LV148-E05 in a practical way, namely that the voltage applied to the ECU should be stable, even under load fluctuations.
The standard says nothing about the measuring location and the load, but the measuring location should be selected at the DUT input (the proof in the unloaded state directly at the output of the generator / amplifier is not expedient).
Measurement technology for electrical quantities
signal processing
amplifier
Isolation measuring amplifier e.g. T303A:
measuring ranges ±0,2V—0,5V –1V– 2V…5kV
frequency range: DC…300kHz;
Low Pass Filter: 100kHz ………..
sensors
measuring case
High voltage for piezo actuators up to 6kV
In the German pavilion.
Click here for more information...
Once again we were able to inspire a broad, international professional audience with our high-end amplifiers at our booth.
The new Trendsetting Power Amplifier System PA-LV124/148 for the various measurement tasks in the automotive sector was of particular interest, which we were able to present with its special features:
Rohrer GmbH, Mess- und Systemtechnik presented their HERO®power precision power amplifiers at this year's Power Analysis & Design Symposium of Omicron Lab. The focus was on the Bode 100, a helpful and useful measuring device to document the frequency and phase behaviour of amplifiers.
Download:
Praesentation beim PowerAnalysis.pdf (208kB)
not only because of HERO®power from Rohrer:
Here we have put together some attractions of our Bavarian metropolis for you.
Menü EIN/AUS
NEWS | DOWNLOADS | SUPPORT | COMPANY
+49 89 89 70 120
info@rohrer-muenchen.de
select: DE | EN | CN| XX